http www mywifiext net setup not working is one of the major issues users face during the installation process for Netgear extenders. This article will cover almost all the troubleshooting steps by which you can surely get access to your To get complete information, stick with the theme till the end.  

Before we start, let’s learn about the main issue that causes setup not to work.

Here are some of the things you need to take care of while accessing 

  1. Make sure that the electrical plug you are using to connect your Netgear extender is not damaged. 
  2. Ensure that you are using an updated version of your web browser on which you are trying to open the web setup portal. 
  3. Sometimes the web address does not respond. Try using the IP address that is and see if it can resolve your issue. 
  4. Check your ethernet cable. If it is damaged, change it.
  5. Keep your firmware updated. 
  6. Check whether your home wifi is providing live internet. If not, call your internet service provider. not working resolved 

Now, we will try to teach you how you can set up your extender and get access to your without any error popups. Follow the step-by-step instructions carefully to do so. 

  1. Disconnect your Netgear extender from the old place and keep it in the same room as your existing router. 
  2. Now plug your extender in an electrical outlet. 
  3. Now take a paper clip or any other pointed object. 
  4. Look for the reset button on your extender and use a paper clip to press and hold it for almost 15 seconds, then release it. 
  5. Let your extender reset to its factory settings. 
  6. Wait for a couple of minutes to let your extender get stable. 
  7. Once done, press and hold the WPS button on your extender for seven seconds, then release it. 
  8. Now repeat the same process with your router, press and hold the WPS button for seven seconds and then release it. 
  9. Take your wifi-enabled PC and launch an updated web browser. 
  10. Click on the address bar and type, and hit the enter button. 
  11. You automatically get redirected to the web setup portal for a new Netgear extender. 
  12. Now enter the admin credentials like your username and password in the given area and hit the login button. 
  13. Now search for the available network in your area. 
  14. Select your extender network and click on it to get connected. 
  15. Once done, complete the on-screen instruction and click the Finish button to save your settings.

Your extender is now successfully connected to your existing network. It’s time to change the location of your extender.   

Keep your extender halfway to your existing wifi and the area where there is no network. Your extender must get proper signals from your existing wifi to perform better.   

Wrap up

If you still face not working, let us know by commenting down below in the comment section. 

Is this information beneficial?   


Please enter your comment!
Please enter your name here